We were called to Phuket, Thailand. There’s been an electrical fire on board of a Lagoon 50. The damage has been repaired by the installer but there are still many issues and the owner has his doubts. We were asked for a second opinion. Well, we’re not going to share much about what we found there, not to compromise our well-respected Thai colleagues but the pictures speak for themselves:

For us, this means only one thing: cut everything out and start all over…

First thing was, make a thorough investigation of all systems and needs and make an electrical diagram.

From our first visits we already knew that not much materials are available locally… So, we had to prepare an extremely detailed list of all materials we needed for the the installation. Every piece of equipment, every cable, every connector, every little screw had to be transported to Langkawi, Malaysia!

In our workshop & storage room, we prepared everything and packed it in crates.

All that was shipped to Langkawi by sea. It took a container vessel 6 weeks to get it there.

But finally, everything was delivered!

Then, we took a flight to Langkawi.

And got to work.

The tool case had been flying with us.

All equipment and materials unpacked on board.

We get to work! First, we remove the entire existing installation except the 2 Victron 8k Quattro’s. On this picture we have started installing the MG Master LV and MG Distributor.

Cutting away a big bunch of old cables…

Installing cable rails.

More cable rail and fitting the batteries.

Installing the main manually operated circuit breaker. This sturdy 2000A switch cuts off the batteries from the system in an emergency.

Breakfast isn’t bad here! 😋

The 8 MG 24v 280Ah 7.2kWh batteries in place. Firmly strapped to the floor.

57.6 kWh at 25.6v of energy storage 👊🏻

Battery cables connected to the BMS. 4 groups of 2 batteries in parallel.

The MG Energy Monitor finds a place outside the battery room.

The Quattro’s and AC system connected.

Solar chargers connected. There’s about 7 kWp PV power on this boat.

Speaking of solar… Every night at dinnertime we have this gorgeous view.

Speaking of dinnertime… we love the Thai food!

And have something to read and to drink 🙂

Meanwhile, we’re working on the Victron 12v battery bank. All the boat’s DC systems are 12v so we need a lot of 12v power.

10 kWh at 12.8v. 4x 200Ah Victron lithium battery.

There are DC-DC converters that charge this battery bank from the main (24v) battery bank. Plus an AC charger that can charge this bank from the Onan genset.

The main energy room is finished.

Testing, testing, testing…

We run all systems at full power. And more. We test overloads, safety systems and extreme situations.

All good!

We have a very happy client 🙂

One last sunset over the marina

After 2 weeks of hard work it’s time to fly home 🛫

Leave a Reply

Your email address will not be published. Required fields are marked *